TM 55-1520-240-23-9
11-65
ASSEMBLE THRUST CONTROL (AVIM)
(Continued)
11-65
NOTE
If a crack in the connecting link is
suspected, refer to TM 1-1520-253-23.
1.
Install pivot block (1) in arbor press. Press
bearing (2) into upper lug (3).
2.
Turn pivot block (1) over. Position stop (4)
between lugs (3 and 5) of pivot block. Align
holes. Slide grooved bushing (6) through hole in
upper lug and into stop. Align bushing groove
with small hole (7) in stop.
3.
Drive slotted spring pin (8) into hole (7) until
centered in stop (4).
4.
Install lockwire (E231) through pin (8).
5.
Place 1/4 inch bolt (9) through lower bearing
(2). Install spacer (10) and bearing (11) on bolt.
Press in bearing until seated on spacer. Remove
bolt. Remove pivot block (1) from arbor press.
11-292