TM 55-1520-240-23-9
11-65
ASSEMBLE THRUST CONTROL (AVIM)
(Continued)
11-65
18.
Coat sleeve bushing (33) with epoxy primer
(E292). While primer is wet, install panel nut (34)
and retainer (35) in bushing. Align holes in nut
and bushing. Wear gloves (E184.1).
19.
Coat top 1-1/2 inches of shaft (19) with epoxy
primer (E292). Wear gloves (E184.1).
NOTE
Assemble shaft and grip while primer
is wet.
20.
Feed cable (36) into large hole (37) on side of
shaft (19). Feed through shaft and out lower
end of shaft.
21.
While primer is wet, install grip (38) on shaft (19).
22.
While primer is wet, install bushing (33) in top
of shaft (19).
23.
Install bolt (39) and washer (40).
11-295
