TM 55-1520-240-23-9
11-63
DISASSEMBLE THRUST CONTROL (AVIM)
(Continued)
11-63
Do not remove pivot block from shaft.
Assembly contains 54 ball bearings
which are matched by manufacturer.
If pivot block is removed, bearings will
fall out.
14.
Support pivot block (12). Drive out lower bearing
(34) and spacer (35). Use pin punch.
15.
Remove lockwire from stop (36).
16.
Drive out retaining pin (37).
17.
Turn pivot block (12) over and install in arbor
press. Press out bearing (38) and bushing (39).
Remove stop (36). Remove pivot block from
arbor press.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-289
