TM 55-1520-240-23-9
11-65
ASSEMBLE THRUST CONTROL (AVIM)
(Continued)
11-65
6.
Coat bearing bores of link (12) with epoxy primer
(E292). Wear gloves (E184.1).
NOTE
Install bearings in link while primer
is wet.
7.
Support small end of link (12) in arbor press.
While primer is wet, press in bearing (13).
Remove from arbor press.
8.
Roller swage both sides of bearing housing (14).
Use drill press and roller staking tool.
9.
Support large end of link (12) in arbor press.
While primer is wet, press in bearing (15).
10.
Turn link (12) over and support in arbor press.
11.
Place 1/4 inch bolt (9) through lower bearing
(15). Install spacer (16) and bearing (17) over
bolt (9). While primer is wet, press in bearing
until seated on spacer. Remove bolt. Remove
link (12) from arbor press.
11-293