TM 55-1520-240-23-9
11-62
REMOVE THRUST CONTROL (COPILOT)
(Continued)
11-62
8.
Remove cotter pin (15), nut (16), washers (17),
and bolt (18).
9.
Remove link (19) from bellcrank (20).
10.
Replace back bolt (18), washers (17), and
nut (16) into bellcrank (20) to prevent loss of
bushings. Do not torque nut.
11.
Remove six screws (21), six washers (22) and
boot (23).
NOTE
To prevent ball bearing loss from
thrust control pivot block, wrap tape
(E388) around thrust control shaft
above and below pivot block.
12.
If applied, remove silicone rubber coating from
cotter pin (24) and nut (25). Remove cotter pin,
nut, washers (26), and bolt (27).
13.
Lift thrust control (28) out of support (29). Guide
cable through hole (30) in floor (31).
14.
Replace bolt (27), washers (26), and nut (25)
into support (29) to prevent loss of bushings. Do
not torque nut.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-284
