TM 55-1520-240-23-4
5-81.1
REPLACE SHOCK ABSORBER BRACKET BUSHINGS
(Continued)
5-81.1
16.
Hold nut (6) and turn rod (5) counterclockwise.
Use two wrenches. Turn rod until bushing (2) is
fully seated in lower plate (10).
17.
Remove rod (5) with nut (6) pusher/guide (4)
and yoke (7).
INSPECT
REMOVE UPPER BUSHING
18.
Place pusher/puller yoke (7) over upper plate (8)
of lag damper bracket. Align hole in yoke with
hole in upper bushing (1).
NOTE
The flanged side of both bushings is
on the upper surface of the bracket
plates.
19.
Install rod (5), with nut (6), through yoke (7) and
bushing (1). Thread pusher/puller (3) on rod (5)
until large pitot (11) is seated in bushing.
20.
Hold nut (6) and turn rod (5) counterclockwise.
Use two wrenches. Turn rod (5) until bushing
(1) is out of plate (8).
21.
Remove pusher/puller (3). Remove rod (5) with
nut (6), bushing (1) and yoke (7).
5-463
