TM 55-1520-240-23-10
16-110
INSTALL ENGINE AIR PARTICLE SEPERATOR
(Continued)
16-110
10.
Push handle down to engage pin latch (14). Pin
should move smoothly through rail bushing and
into slide bushing. Use adjusting screw, located
on fwd outboard slide block, to align pin with
bushing if necessary.
11.
Hold adjusting screw with hex head wrench and
tighten lock nut.
12.
Engage hook latch (13) with clevis block and
close handle. A small amount of force should be
required. Adjust hook if necessary.
13.
Install quick release pins (12) in pin latch (14)
and hook latch handles (13).
14.
Place upper cross shaft seal over cross shaft
fairing and attach to lower cross shaft seal with
two shoulder bolts.
15.
Position seal assemblies firmly against EAPS
and connect latches (14). Install safety clips in
latches. P-seals on upper and lower cross shaft
seal must have contact with cross shaft fairing
and EAPS at all points.
16.
Install cross shaft link (9) in EAPS and engage
Camloc. P-seals on cross link must make contact
with mating surfaces at all points.
17.
Install fwd bump stop (4) on inboard and
outboard rail (5) and attach using two bolts (3),
washers (2), and nuts (1). Torque nuts to 70 to
90 inch-pounds.
16-370
