TM 55-1520-240-23-7
9-102
INSTALL OVERHEAD PANEL LIGHTING POTENTIOMETER
(Continued)
9-102
NOTE
Procedure is similar to install CTR
SECT INST LTS resistor, PILOT OR
COPILOT INST LTS resistor, FLOOD
LTS resistor, CONSOLE LTS resistor,
DOME LTS resistor, and OVERHEAD
PANEL LIGHTS resistor. Installation
of CONSOLE LTS resistor is shown
here.
1.
Position resistor (1) in panel (2). Install nut (3)
and washer (4).
2.
Position panel (5) on panel (2). Install three
holders (6).
3.
Install three knobs (7). Tighten three screws (8).
4.
Remove tape and solder eight wires (9) to
resistor (1). Use solder (E360). Remove tags.
5.
Raise panel (10). Install two bolts (11) and
washers (12).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform operational check (TM 55-1520-240-T).
END OF TASK
9-413
