TM 55-1520-240-23-7
9-101.2
INSTALL OVERHEAD PANEL LIGHTING POTENTIOMETER, LIGHTING CONTROL
TRANSFORMERS, OR ROTARY SWITCH
(Continued)
9-101.2
10.
Install panel (2) in overhead panel (16).
11.
Remove tape and install wire (17), washer (18),
and screw (19) on light housing (20). Remove
tag.
12.
Remove tape and install wire (21). Solder wire
end (22) onto terminal (23) of housing (20).
Remove tag.
13.
Remove tape and install six wires (24), washers
(25), and nuts (26) on transformers (1 and 14).
Remove tags.
INSPECT
FLOODLIGHTING POTENTIOMETER — INTR LTG
PANEL
14.
Position INTR LTG resistor (27) in INTR LTG
panel (28).
15.
Install knob (20) on resistor (27).
16.
Hold resistor (27). Turn knob (29) fully
counterclockwise.
17.
Align resistor with holes (30), knob (29) pointing
towards screw hole (31).
18.
Remove knob (29).
19.
Install four screws (32) in resistor (27).
20.
Install panel (33) on panel (28). Tighten two
screws (34).
21.
Install knob (29) on resistor (27). Tighten screw
(35).
9-408
