TM 55-1520-240-23-4
5-48.5
INSTALL DROOP STOP SHROUD
5-48.5
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanics Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 0 to 150 Inch-Pounds
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
There are three droop stop shrouds.
Procedure is same to install any
shroud.
1.
Position droop stop shroud (1), hinged cover (2)
up, on rotor head (3).
2.
Install screws (4) and washers (5 and 6) in
shroud (1). Torque screws to 22 inch-pounds.
3.
Install bolt (7) and washers (8 and 9) in shroud
(1). Torque bolt to 110 inch-pounds.
FOLLOW-ON MAINTENANCE:
Install droop stop shroud base (Task 5-48.6).
Install droop stop shroud shield (Task 5-48.7).
Close aft work platforms (Task 2-2).
Remove tiedown lines from blades.
END OF TASK
5-214