TM 55-1520-240-23-4
5-48.7
INSTALL DROOP STOP SHROUD SHIELD
5-48.7
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 5 to 50 Inch-Pounds
Materials:
Lockwire (E231)
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
There are three droop stop shroud
shields. Procedure is same to install
any droop stop shroud shield.
1.
Position droop stop shroud shield (1) on droop
stop (2). Install two washers (3) and two bolts
(4). Torque bolts to 22 inch-pounds.
2.
Lockwire bolts (4). Use lockwire (E231).
FOLLOW-ON MAINTENANCE:
Close aft pylon work platforms (Task 2-2).
Remove tiedown lines from blades.
END OF TASK
5-217
