TM 55-1520-240-23-4
5-48.2
REMOVE DROOP STOP SHROUD BASE
(Continued)
5-48.2
NOTE
There are three droop stop shroud
bases. Procedure is same to remove
any base.
1.
Remove four bolts (1) and washers (2) from
shroud base (3).
2.
Remove lockwire from bolts (4 and 5). Remove
bolt (5) and washer (6).
3.
Remove two cotter pins (7), nuts (8) washers (9),
and bushings (10) from shaft (11).
4.
Slide droop stop shroud base (12) from shaft
(11) through slots (13). Remove base.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
5-211