TM 55-1520-240-23-4
5-48.6
INSTALL DROOP STOP SHROUD BASE
5-48.6
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 5 to 150 Inch-Pounds
Materials:
Lockwire (E231)
Parts:
Cotter Pins
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
There are three droop stop shroud
bases. Procedure is same to install
any base.
1.
Align slots (1) of droop stop shroud base (2) with
shaft (3). Slide base on shaft.
2.
Install bushings (4), flange outboard, on shaft (3).
3.
Install washers (5) and nuts (6). Do not tighten
nuts at this time.
5-215
