TM 55-1520-240-23-4
5-48.3
REMOVE DROOP STOP SHROUD
5-48.3
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
Aft Work Platform Open (Task 2-2)
Tiedown Line On One Forward and One Aft Blade
(Task 1-26)
Droop Stop Shroud Shield Removed (Task 5-48.1)
Droop Stop Shroud Base Removed (Task 5-48.2)
NOTE
There are three droop stop shrouds.
Procedure is same to remove any
shroud.
1.
Remove bolt (1) and washers (2 and 3) from
droop stop shroud (4).
2.
Remove two screws (5) and washers (6 and 7)
from shroud (4).
3.
Remove shroud (4) from rotor head (8).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
5-212
