TM 55-1520-240-23-4
5-35
INSTALL VERTICAL HINGE PIN INNER SEAL
(Continued)
5-35
NOTE
All sealants and adhesives have
different cure times. When using
sealants and adhesives, the directions
on the container are to be considered
minimum cure time before full
operation of the aircraft.
8.
Wipe squeezeout from seal (1) and lug (4 or
5). Use cloth (E120) damp with solvent (E162).
Wear gloves (E186).
9.
Cure adhesive on seal for 1 hour.
Wipe off excess grease. Grease can
foul passages and restrict oil flow.
10.
Apply grease (E190) between lips (2) of seal (1).
Remove excess grease. Wear gloves (E186).
NOTE
Lower inner bearing race and guide
plug are smaller in diameter than
upper race and guide plug. Lower
race is also longer than upper race.
11.
Select inner race (10 or 11) and guide plug (T12)
(12 or 13) for upper lug (5) or lower lug (4). Insert
plug in inner race.
12.
Apply film of oil (E254/E254.1) to outside of inner
race (10 or 11) and guide plug (T12) (12 or 13).
13.
Position thrust washer (14) on inner race (10).
14.
Push plug (T12) (12) and inner race (10) into lug
(4 or 5) until race is seated. Use gloves (E186).
Remove plug (T12).
INSPECT
FOLLOW-ON MAINTENANCE:
Install vertical hinge pin tank (Task 5-29).
Install rotary-wing blade (Task 5-84).
Close work platform (Task 2-2).
END OF TASK
5-162
