TM 55-1520-240-23-4
5-35
INSTALL VERTICAL HINGE PIN INNER SEAL
(Continued)
5-35
NOTE
Adhesive (E63.1) or sealant (E340.3)
is authorized specifically for the
installation of vertical hinge pin seals.
3.
Apply adhesive (E63.1) or sealant (E340.3) to
seal recess (3) and outer wall of seal (1). Wear
gloves (E186).
4.
Position seal (1) on lug (4 or 5), open side toward
recess (3).
5.
Position base of seal puller (T10) (6) on seal (1).
Position driver (7) on lug (4 or 5). Install bolt (8)
and washer (9) through driver and base.
Do not press seal past lug surface.
Too much pressure can damage seal
and cause leaks.
6.
Turn bolt (8) clockwise until base of seal puller
(T10) (6) pulls seal (1) flush with lug (4 or 5).
7.
Turn bolt (8) counterclockwise. Remove bolt,
washer (9), driver (7), and base of seal puller
(T10) (6).
5-161
