TM 55-1520-240-23-10
16-27
ASSEMBLE FORWARD OR AFT CARGO HOOK (AVIM)
(Continued)
16-27
50.
Install latch bumper (96). Position bumper so
that latch (81) will strike area of bumper not
previously contacted.
51.
Install two bumpers (97).
52.
Install two fitting bumpers (98) in fitting (99).
Install fitting in rear plate (25), raised shoulder
forward.
INSPECT
53.
Coat mating surfaces of front plate (3) and rear
plate (25) with adhesive (E57). Wear gloves
(E184.1).
Do not force or hammer plates to seal
plates together. Damage to plates
can result.
54.
Position front plate (3) on rear plate (25).
55.
Apply primer (E292) under bolt heads (100, 101,
and 102), on washers (103), and under nuts
(104). Wear gloves (E184.1).
56.
Install four short bolts (100), bolt (101), and
washers (103), while primer is wet. Install long
bolt (101) and washer (103) in hole closest to
cap (24), while primer is wet.
57.
Hold two plates (3 and 25) together and rotate
180º. Install washers (103) and nuts (104) on
four bolts (100), while primer is wet.
58.
Apply sealant (E340.1) to two packings (105)
both sides. Install packings, two washers (102),
and two nuts (104) on bolts (101 and 102) while
primer is wet. Wear gloves (E184.1). Torque nuts
to 120 inch-pounds.
16-148
