TM 55-1520-240-23-10
16-27
ASSEMBLE FORWARD OR AFT CARGO HOOK (AVIM) (Continued)
16-27
67.
Position gasket (131) on rear plate (25).
68.
Connect harness wires (132) to modules (123).
Use insertion/extraction tool.
69.
Route wire harness (127) below modules (123)
and install three straps (133). Use strap tool.
70.
Position solenoid cover (130) on rear plate (25)
and install seven bolts (134), bolt (134.1), and
washers (135). Torque bolts to 35 inch-pounds.
70.1. Install packing (135.1), washer (135.2), and
bolt (135.3) in solenoid cover (130). Torque
bolt (135.3) to 50 inch-pounds. Lockwire bolt
(134.1) to bolt (135.3). Use lockwire (E231).
71.
Position spring (136) in keeper (137) and install
bushing (138).
72.
Position keeper (137) between front plate (3) and
rear plate (25), use cotter pin extractor (139) to
depress spring (136) into position, as keeper is
installed.
73.
Install bolt (140), two washers (141), nut (142),
and cotter pin (143).
74.
Install bumper (144). Bumper should be fit tight.
Install bolt (145), two washers (146), nut (147),
and cotter pin (148).
16-150
Change 1
