TM 55-1520-240-23-10
16-27
ASSEMBLE FORWARD OR AFT CARGO HOOK (AVIM)
(Continued)
16-27
14.
Remove tag and install packing (36) on shaft
(39). Install shaft in insert (29).
15.
Install arm (40) on shaft (39). Install pin (41) in
arm and shim with washers (41.1) as required
to remove end play. Lockwire pin. Use lockwire
(E227).
16.
Remove tag and install packing (42) on shaft
(43). Install shaft in insert (30).
17.
Install arm (44) on shaft (43). Install pin (45) in
arm and shim with washers (41.1) as required
to remove end play. Lockwire pin. Use lockwire
(E227).
18.
Remove tag and install packing (46) on shaft
(47). Install shaft in insert (31).
19.
Install arm (48) on shaft (47). Install pin (49) in
arm and shim with washers (41.1) as required
to remove end play. Lockwire pin. Use lockwire
(E227).
20.
Apply lubricant (E238.1) to OD of seal (50).
Wear gloves (E184.1). Install seal and retainer
ring (51) in shaft support (52).
Lubricant (E238.1) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
21.
Deleted.
22.
Apply sealant (E340.1) to support (52) inside
surface and seal (50). Position gasket (53) and
install shaft support (52) in rear plate (25). Use
arbor press. Wear gloves (E184.1).
23.
Install gasket (54) on solenoid (55). Position
solenoid in shaft support (52), rotate rear plate
(25) and solenoid (55) 180º.
24.
Apply sealant (E340.1) to plate (25), around
solenoid shaft (58), and studs (56.1), and to both
sides of two packings (57). Install packings on
studs. Wear gloves (E184.1).
25.
Install washers (58) and nuts (59) on solenoid
(55). Torque nuts to 72 inch-pounds.
16-144
