TM 55-1520-240-23-10
16-27
ASSEMBLE FORWARD OR AFT CARGO HOOK (AVIM)
(Continued)
16-27
6.
Coat mount surface of three bushing holes (13)
and two pin mount holes (14) with primer (E292).
Wear gloves (E184.1).
7.
Press in three bushings (15, 16, 17), stop pin
(18), and retainer pin (19). Use arbor press.
Adhesive (E43) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
8.
Coat mount surface of pin boss holes (20) and
latch bearing hole (21) with adhesive (E43).
9.
Install pin boss (22) and latch bearing (23). Use
arbor press.
10.
Coat threads of caps (24) with Loctite (E343).
Wear gloves (E184.1). Install two caps (24), one
on front cover plate (3) over latch bearing (12),
and one on rear plate (25) over latch bearing
(23). Use crowfoot attachment.
11.
Install three packings (26, 27, 28) on inserts (29,
30, 31). Install inserts in rear plate (25).
12.
Install three washers (32, 33, 34) and nuts (35,
36, 37). Torque nuts to 120 inch-pounds.
13.
Apply grease to inside of three inserts (29, 30,
31). Use grease (E190).
16-143
