• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL LINEAR TRANSDUCER  END  FITTING BEARING (AVIM)
ADJUST ROLL OR  YAW  CONTROL POSITION  TRANSDUCER  (CPT)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  685    686    687    688    689  690  691    692    693    694    695  
TM  55-1520-240-23-9 11-175 INSTALL LINEAR  TRANSDUCER END  FITTING  BEARING (AVIM) (Continued) 11-175 1. Place  bearing  (1)  in  small  plastic  bag.  Seal  bag. Place  bag  in  carbon  dioxide  (dry  ice)  (E92)  and methanol  (E243).   Wear  Kevlar  gloves  (E187). Allow  bearing  to  cool  thoroughly. Epoxy  primer  (E292)  is  flammable and  toxic.   It  can  irritate  skin  and cause  burns.  Use  only with  adequate ventilation,  away  from  heat  and open  flame.  Avoid  contact  with  skin, eyes,  or  clothing.  In  case  of  contact, immediately  flush  skin  or  eyes  with water  for  at  least  15 minutes.   Get medical  attention  for  eyes. 2. Coat  bore  of  end  fitting  (2)  with  epoxy  primer (E292).   Wear  gloves (E184.1). 3. Support transducer  (3)  in  arbor  press (4).  Side of  end  fitting  (2)  from  which  old  bearing  was pressed,  must face  up. NOTE Work  quickly  with  chilled  bearing. Bearing  must  be  installed  before  it warms. 4. Remove  bearing  (1)  from  dry  ice.   Remove bearing  from  plastic bag.   Wipe  clean  with  cloth (E120).   Wear  Kevlar  gloves  (E187). 5. While  primer  is  wet  position  bearing  (1)  on  end fitting  (2).   Wear  Kevlar  gloves  (E187).   Press bearing  fully into end fitting (TM  55-1500-322-24). Remove  transducer  (3)  from  arbor  press  (4). 6. Stake  bearing  (1)  with  self-centering circumferential  line  staking  tool  (TM 55-1500-322-24). 7. Wipe  off excess primer  from  end  fitting  (2).  Use cloth  (E120). FOLLOW-ON  MAINTENANCE: None END  OF  TASK 11-696







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.