• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  LINEAR TRANSDUCER ROD  END  BEARING (AVIM)
REMOVE  LINEAR TRANSDUCER END FITTING BEARING  (AVIM)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  682    683    684    685    686  687  688    689    690    691    692  
TM  55-1520-240-23-9 11-173 INSTALL LINEAR TRANSDUCER ROD END BEARING (AVIM) (Continued) 11-173 5. Install  rod  end  assembly  (2,  1,  3,  and  5) into transducer (7).   Adjust  so  that  dimension  A  is 1-3/8  inches. 6. Engage  tabs (8) of inner part (5) of locking  device with  slots (9) in  end  of  transducer  (7). 7. Tighten  nut  (1).  Hold  transducer (7) with  wrench on  hexagon  (10). INSPECT NOTE Do  not lockwire  at  this time.  Nut  shall be  lockwired  after final  adjustment during  helicopter  flight  controls rigging. FOLLOW-ON MAINTENANCE: None END  OF  TASK 11-693







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.