• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TIP  SEAL   MAJOR  REPAIR (AVIM)
TIP  SEAL   MAJOR  REPAIR  (AVIM) (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  433    434    435    436    437  438  439    440    441    442    443  
TM  55-1520-240-23-4 5-77 TIP  SEAL — MAJOR  REPAIR  (AVIM) (Continued) 5-77 NOTE This  repair not  applicable  to  blades with  tip  sealant covered  by  fiberglass doubler. 1. Remove  loose  or  damaged  material  (1) from  tip sealant  (2).   Use  pocket  or  utility  knife. 2. Check  for bond  voids  in  sealant  (2).   Voids are indicated  by  soft  spots.   Remove  sealant  to expose  voids. 3. Trim  material  around  damage  (1)  to  a  feather edge. 4. Clean  damaged  area  (1).  Use  cloth  (E120) damp with  acetone  (E20).  Wear gloves  (E186). 5. Wipe  area  dry.  Use  cloth  (E120). 6. Mask  fairing  skin,  and  trailing  edge  of  tip  cover,  if necessary.  Use  Teflon  tape  (E399). 7. Cut  piece  of  aluminum  (E70) (3) to  4  inch x 18 inch  size. 8. Position piece  of Teflon  tape  (E399) (4) adhesive, side  up, on  aluminum  sheet  (E70) (3).  Hold  tape (4)  in  place.   Apply  tape  (E399) (5) over  entire plate  (3)  and  tape  (4). 5-442







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.