• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPLACE  LIGHTNING PROTECTION  JUMPER WIRE
REPLACE  LIGHTNING PROTECTION JUMPER  WIRE (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  436    437    438    439    440  441  442    443    444    445    446  
TM  55-1520-240-23-4 5-77.1 REPLACE  LIGHTNING PROTECTION  JUMPER WIRE (Continued) 5-77.1 2. Remove  bolt  (1)  and  three  washers  (3)  to disconnect  jumper  wire  (2) from  blade  (4). 3. Remove  bolt  (5)  and  washer  (6) to  disconnect jumper wire  (2) from  oil  manifold  tube  (7). 4. Remove  jumper wire  (2) from  clamp  (8). INSTALL JUMPER  WIRE 5. Remove  paint and  sealant from strip  (9) 2 inches wide  along  jumper wire  path  and  around  insert (10).   Expose  fiberglass/epoxy  surface.   Use abrasive  paper  (E9). 6. Wipe  the  prepared  area.  Use  cloth  (E120)  damp with  acetone  (E20).  Wear  gloves (E184.1).  Wipe with  a  clean  dry cloth  before  acetone  evaporates. Make  sure  insert (10)  is  free  of  foreign  matter. 7. Position  one  end  of  jumper  wire  (2)  on  oil manifold  tube  (7).  Install  washer (6) and  bolt  (5). Torque  bolt  to  35 inch-pounds. 8. Position  two  washers (3) and  other  end  of jumper wire  (2) on  insert (10).   Install  third  washer  (3) and  bolt  (1).  Torque  bolt  to  30 inch-pounds. 9. Install  jumper  wire  (2) in  clamp  (8). 5-445







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.