TM 55-1520-240-23-9
11-17
REMOVE DAMAGED RIG PIN FROM THRUST CONTROL
(Continued)
11-17
23.
Working from passageway, position link (7) in
bellcrank (6). Install bolt (5), two washers (4 and
3) and nut (2).
24.
Torque nut (2) to 30 to 45 inch-pounds. Install
cotter pin (1).
25.
Check bolt (5). Bolt shall not rotate with torque
less than 10 inch-pounds. There shall be no
axial looseness. If bolt rotates or is loose, add
washer under nut and repeat step 24.
26.
Rig thrust control (Task 11-43).
Acetone (E20) is extremely flammable.
It can be toxic. Avoid inhaling. Use
only with adequate ventilation. Avoid
contact with skin, eyes, or clothing.
Keep away from heat, sparks, or open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
27.
Clean sealant from flange (41) and inside surface
(42) of access (15). Use acetone (E20) and
cloths (E120). Wear gloves (E186).
28.
Support housing (14). Remove strap (18).
Sealant (E336) is flammable and toxic.
It can irritate skin and cause burns.
Use only with adequate ventilation,
away from heat or open flame. Avoid
contact with skin, eyes, or clothing.
In case of contact, immediately flush
skin or eyes with water for at least
15 minutes. Get medical attention
for eyes.
29.
Apply sealant (E336) to both sides of (new)
gasket (17). Install gasket on flange (41).
Remove excess sealant with acetone (E20) and
cloths (E120). Wear gloves (E186).
30.
Tilt housing (14) and position inside access (15),
lamp (43) aft. Align housing and access holes
(44).
11-73
