TM 55-1520-240-23-9
11-89
REMOVE CONTROL PALLET STA 95
(Continued)
11-89
NOTE
Attaching bolts, washers, and nuts will
be temporarily installed after removing
links.
2.
On helicopters with 74 , perform the following
steps:
a.
Tag and disconnect connector (1) from yaw
magnetic brake (2). Use tag (E264).
b.
Tag and disconnect connector (3) from thrust
CCDA (4). Use tag (E264).
c.
Tag and disconnect two connectors (5) of
yaw CPT (6). Use tag (E264).
d.
Tag and disconnect three electrical
connectors (7) from thrust potentiometer (8).
Use tag (E264).
3.
Tag yaw input link (19). Remove cotter pin (20),
nut (21), and washer (22) from bolt (23). Slide
bolt outboard to release link from yaw idler
bellcrank (24). Disconnect link.
4.
Install bolt (23), washer (22), and nut (21) loosely
in bellcrank (24).
5.
Tag thrust input link (25). Remove cotter pin (26),
nut (27), and washer (28) from bolt (29). Slide
bolt outboard to release link from thrust idler
bellcrank (30). Disconnect link.
6.
Install bolt (29), washer (28), and nut (27) loosely
in bellcrank (30).
7.
Pull edge of blanket (31) away from bulkhead
(32).
8.
Have helper support control pallet (33). Working
in cockpit, remove eight bolts (34) and washers
(35) from pallet and bulkhead (32). Remove
pallet.
FOLLOW-ON MAINTENANCE:
Repair control pallet (Task 11-90.1).
END OF TASK
11-480
