TM 55-1520-240-23-9
11-89
REMOVE CONTROL PALLET STA 95
11-89
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
Paper Tags (E264)
Personnel Required:
Medium Helicopter Repairer (2)
References:
TM 1-1520-253-23
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
Servocylinder Safety Blocks (T31) Installed (Task
11-28)
Closet Acoustic Blanket Removed (Task 2-107)
Closet Backup Panel Opened (Task 2-2)
Thrust and Yaw Connecting Links Removed (Task
11-105)
NOTE
Attaching bolts, washers, and nuts will
be temporarily installed after removing
links.
NOTE
If a crack in the connecting links or
bellcrank is suspected, refer to TM
1-1520-253-23.
1.
On helicopters without 74 , perform the following
steps:
a.
Tag and disconnect connector (1) from yaw
magnetic brake (2).
b.
Tag and disconnect connector (3) from thrust
CCDA (4).
c.
Tag and disconnect two connectors (5) of
yaw CPT (6).
d.
Tag eight electrical wires (7) from thrust
potentiometer (8). Remove eight nuts (9)
and washers (10) from terminal block (11).
Disconnect wires.
e.
Remove two screws (12) from clamps (13
and 14). Remove clamps.
f.
Remove nut (15), spacer (16), screw (17),
and clamp (18) from wire (7).
11-479
