TM 55-1520-240-23-9
11-61
REMOVE THRUST CONTROL (PILOT)
(Continued)
11-61
7.
Remove cotter pin (18), nut (19), washers (20),
and bolt (21).
8.
Remove link (22) from bellcrank (23).
9.
Install bolt (21), washers (20), and nut (19) in
bellcrank (23) to prevent loss of bushings. Do
not torque nut.
10.
Remove six screws (24) and washers (25) and
boot (26).
11.
If applied, remove silicone rubber coating from
cotter pin (27) and nut (28). Remove cotter pin,
nut, washers (29), and bolt (30).
12.
Lift thrust control (31) from support (32). Guide
electrical cable through hole (33) in floor (34).
13.
Replace bolt (30), washers (29), and nut (28)
into support (32) to prevent loss of bushings. Do
not torque nut.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-281