INSTALL DASH ACTUATOR DUMMY LINK

REMOVE COCKPIT RIGGING PITCH, ROLL, YAW, OR ROLL/YAW TRAVEL QUADRANTS (Continued) REMOVE ROLL OR ROLL/YAW TRAVEL QUADRANT

REMOVE DASH ACTUATOR DUMMY LINK

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
91

TM 55-1520-240-23-9 11-26 INSTALL DASH ACTUATOR DUMMY LINK 11-26 INITIAL SETUP Applicable Configurations: All Tools: Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692 Dummy Link (T42) Materials: None Personnel Required: Medium Helicopter Repairer Inspector Equipment Condition: Battery Disconnected (Task 1-39) Electrical Power Off Hydraulic Power Off Safety Blocks (T31) Installed (Task 11-28) Closet Acoustic Blanket Removed (Task 2-107) Closet Backup Panel Removed (Task 2-2) DASH Actuator Removed (Task 11-163) 1. Remove nut (1), three washers (2, 3, and 4), bushing (5), and bolt (6) from ILCA bellcrank (7). 2. Position dummy link (T42) (8) in bellcrank (7). Install bolt (6), three washers (4, 3, and 2), bushing (5), and nut (1). 3. Remove nut (9), three washers (10, 11, and 12), bushing (13), and bolt (14) from pitch transfer bellcrank (15). 4. Position dummy link (T42) (8) in bellcrank (15). Install bolt (14), three washers (12, 11, and 10), and nut (9). INSPECT FOLLOW-ON MAINTENANCE: None END OF TASK 11-93

Privacy Statement
Press Release
Contact