TM 55-1520-240-23-9
11-25
REMOVE COCKPIT RIGGING PITCH, ROLL, YAW, OR ROLL/YAW TRAVEL
QUADRANTS
(Continued)
11-25
REMOVE ROLL OR ROLL/YAW TRAVEL QUADRANT
NOTE
Procedure is same to remove roll
or roll/yaw travel quadrants. Roll
quadrant is shown here.
3.
Remove bolt (8) from clamp (9). Turn clamp 90º.
Remove clamp from stick (10).
4.
Install bolt (8) in clamp (9).
5.
Press CENTERING DEVICE RELEASE switch
(11) of grip (12). Move stick (10) forward about 4
inches. Release switch.
6.
Remove pin (13) from fixture (3).
7.
Lift and remove roll quadrant (14) from fixture (3).
8.
Press switch (11). Position stick (10) at neutral.
Release switch.
REMOVE PITCH TRAVEL QUADRANT
9.
Remove pin (13) from fixture (3).
10.
Lift and remove pitch travel quadrant (15) from
fixture (3).
11.
Remove bolt (16) from clamp (17). Remove
clamp from stick (10).
INSPECT
FOLLOW-ON MAINTENANCE:
Remove pilot’s or copilot’s rigging fixture (T39) (Task
11-23).
Remove servocylinder safety block (T31) (Task
11-29).
Remove hydraulic power.
Remove electrical power.
Install pilot’s or copilot’s floor panels (Task 2-82).
END OF TASK
11-92
