TM 55-1520-240-23-9
11-24
INSTALL COCKPIT RIGGING PITCH, ROLL, YAW OR ROLL/YAW TRAVEL
QUADRANTS
(Continued)
11-24
3.
Remove bolt (8) of pointer clamp (9). Open
clamp and position on stick (5) touching elbow
(10).
4.
Align pointer (11) with line (12) on surface (6).
5.
Install bolt (8) in clamp (9). Tighten bolt.
INSPECT
INSTALL ROLL OR ROLL/YAW TRAVEL QUADRANT
NOTE
Procedure is same to install roll
or roll/yaw travel quadrants. Roll
quadrant is shown here.
6.
Remove pitch travel quadrant (Task 11-25).
7.
Remove bolt (13) of clamp (14). Open clamp
and position on stick (5) touching elbow (10) with
pin (15) right.
8.
Install bolt (13) in clamp (14) loosely.
9.
Press CENTERING DEVICE RELEASE switch
(16). Move stick (5) forward about 4 inches.
Release switch.
10.
Position rod (17) of roll travel quadrant (18) in
hole (3) of fixture (4) with marked surface (19) aft.
11.
Align holes of fixture (4) and rod (17). Install pin
(7) in fixture.
12.
Press switch (16). Move stick (5) aft until pin (15)
aligns with slot (20) in quadrant (18).
13.
Turn clamp (14) to position pin (15) in slot (20)
of quadrant (18). Align with NEUTRAL slot (21).
Release switch (16), then tighten bolt (13) of
clamp (14).
11-89
