TM 55-1520-240-23-9
11-24
INSTALL COCKPIT RIGGING PITCH, ROLL, YAW OR ROLL/YAW TRAVEL QUADRANTS
11-24
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Cockpit Controls Rigging Tools (T39)
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Inspector
Equipment Condition:
Battery Connected (Task 1-39)
Electrical Power On
Hydraulic Power On
Servocylinder Safety Blocks (T31) Installed (Task
11-28)
Pilot’s or Copilot’s Rigging Fixture (T39) Installed
(Task 11-22)
NOTE
Procedure is same to install pilot’s
or copilot’s cockpit rigging pitch, roll,
yaw, or roll/yaw travel quadrants.
Copilot’s rigging quadrants are shown
here.
NOTE
Ensure that pitch travel quadrant has
been modified/marked with "ADCN3".
Do not use unmodified/unmarked
pitch travel quadrant. Contact
the local AMCOM LAR for rework
procedures.
INSTALL PITCH TRAVEL QUADRANT
1.
Position rod (1) of pitch travel quadrant (2) in hole
(3) of fixture (4) on left of stick (5) with marked
surface (6) to left.
2.
Align holes of fixture (4) and rod (1). Install pin
(7) in fixture.
11-88
