TM 55-1520-240-23-6
7-214
DISASSEMBLE AND INSPECT UTILITY RESERVOIR/COOLER (AVIM)
(Continued)
7-214
3.
Remove nut (7), and elbow (8) from manifold (3).
4.
Remove cotter pin (9), pin (10), and supply tube
(6) from manifold (3).
5.
Remove two packings (11) from tube (6).
5.1.
Measure outside diameter of ends of tube (6).
Diameter shall not be less than 1.13 inches.
Ends shall not be out of round more than 0.003
inch.
5.2.
Check tube (6) for dents and scratches. Dents
shall not be deeper than 0.180 inch. Scratches
shall not be deeper than 0.010 inch.
6.
Remove lockwire, six screws (12), two joints (13),
and two transfer tubes (14) from reservoir (2).
7.
Remove two packings (15) from each tube (14).
8.
Remove nut (16), three washers (17), and screw
(18) from reservoir (2) and cooler (19).
9.
Remove lockwire, three screws (20), and three
washers (21) from bracket (22).
10.
Remove two screws (23), two washers (24), and
link (25).
11.
Remove nipple (26) from reservoir (2).
12.
Remove packing (27) from nipple (26).
13.
Remove cooler (19) from reservoir (2).
7-813
