TM 55-1520-240-23-6
7-214
DISASSEMBLE AND INSPECT UTILITY RESERVOIR/COOLER (AVIM)
7-214
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891
Deep Well Socket, 7/16 Inch
Technical inspection Tool Kit, NSN 5180-00-323-5114
Outside Micrometer Caliper, 1 to 2 Inch
Materials:
Cloths (E120)
Gloves (E186)
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
TM 1-1520-253-23
Task 7-1.1
Equipment Condition:
Off Helicopter Task
General Safety Instructions:
Hydraulic fluid (E199) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
General inspection criteria (Task
7-1.1) for obvious damage applies
unless otherwise stated.
Inspection steps cover parts that are
subject to wear.
1.
Remove tube (1) between reservoir (12) and
manifold (3). Use gloves (E186).
1.1.
Check tube (1) for dents and scratches Dents
shall not be deeper than 0.050 inch Scratches
shall not be deeper than 0.004 inch.
2.
Remove lockwire, three screws (4), three
washers (5), and manifold (3) with supply tube
(6) from reservoir (2).
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
7-812
