TM 55-1520-240-23-6
7-88
INSTALL INTEGRATED LOWER CONTROL ACTUATOR (ILCA) CROSS FEEDBACK
TRANSDUCER (AVIM)
7-88
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891
Torque Wrench, 5 to 50 Inch-Pounds
Materials:
Lockwire (E231)
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
TM 55-1520-240-23P
Task 7-98
NOTE
Procedure is same to install cross
feedback transducer on roll, pitch, or
yaw actuator.
1.
Install nut (1) on probe (2).
2.
Position transducer (3) on actuator (4). Install
two screws (5).
3.
Torque two screws (5) to 23 inch-pounds.
4.
Lockwire screws (5) to actuator (4). Use lockwire
(E231).
5.
Install probe (2) in rod end (6). Turn probe into
rod end same number of turns as recorded.
If number of turns is not available, turn probe
into rod end until distance from end of rod end
to transducer housing (7) is 1.175 inches (as
shown).
6.
Perform Extensible Link Self Feedback
Transducer Null Voltage Test (SPARE) (Task
7-98).
7.
Torque nut (1) to 23 inch-pounds. Lockwire
nut to probe (2) and rod end (6). Use lockwire
(E231).
7-355
