TM 55-1520-240-23-6
7-87
REMOVE INTEGRATED LOWER CONTROL ACTUATOR (ILCA) CROSS FEEDBACK
TRANSDUCER (AVIM)
7-87
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairers Tool Kit, NSN 5180-00-323-4891
Materials:
Paper Tags (E264)
Personnel Required:
Aircraft Pneudraulics Repairer
Equipment Condition:
Off Helicopter Task
NOTE
Procedure is same to remove cross
feedback transducer on roll, pitch, or
yaw actuator.
1.
Tag and disconnect two electrical plugs (1) from
transducer (2).
2.
Remove lockwire from two screws (3) and locknut
(4).
NOTE
Count number of turns needed to
remove probe.
3.
Loosen locknut (4) and remove probe (5) from
rod end (6). Count number of turns to remove
probe and record.
4.
Remove two screws (3).
5.
Remove transducer (2).
6.
Remove nut (4) from probe (5). Retain nut for
installation.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
7-354