TM 55-1520-240-23-5
6-97
INSTALL AFT TRANSMISSION
(Continued)
6-97
TORQUE NUTS
NOTE
Torque shaft and torque adapter are
part of torque adapter assembly
(T160).
To avoid binding during transmission
installation, centerline of adapter shall
be directly under or slightly left of
transmission centerline.
15.
Install torque adapter (19) between structure
(20) at sta. 534 and structure (20.1) at sta. 594.
Flat side of base plate (21) shall face aft. Center
adapter under transmission (1) and tighten four
hand knobs (21.1). Make sure centerline of
adapter is not right of transmission centerline.
Make sure ratchet selector on torque
pack is set to NUT ON before applying
torque. Changing ratchet settings with
torque applied can damage unit and
cause injury to personnel.
15.1.
Set ratchet selector (22) on torque pack (T23)
(23) to NUT ON.
NOTE
Adapter is part of torque pack (23).
15.2.
Install adapter (24) in torque pack (T23) (23).
Install torque pack on support (25) with two
hooks (25.1). Make sure two pins (26) on bottom
of torque pack engage holes in support. Check
that torque indicator (26.1) faces aft and inboard.
15.3.
Secure torque pack (23) to support (25). Use two
thumb screws (26.2).
6-368
