TM 55-1520-240-23-5
6-97
INSTALL AFT TRANSMISSION
(Continued)
6-97
CONNECT TRANSMISSION
17.
Slide exhaust duct (29) forward against fan (30).
Coat thread of clamp (31) with oil (E254). Install
clamp around duct and fan. Torque clamp to 35
inch-pounds.
18.
Connect oil hose (32) to adapter (33).
19.
Connect electrical connector (34) to indicating
screen and chip detector (35). Connect electrical
connector (36) to temperature bulb (37). Install
four clamps (38) to clips (39) on sump (40) with
screws (41), washers (42), and nuts (43).
20.
Connect electrical connector (44) to main
oil pressure switch (45). Connect electrical
connector (46) to auxiliary oil pressure switch
(47).
Do not kink hoses when handling
pump.
21.
Pack splines of flight control hydraulic pump
(48) and mating splines in transmission (1) with
grease (E190). Install pump, with packing (49),
and gasket (49.1), on four studs (50). Install nuts
(51). Torque nuts to 85 inch-pounds.
Do not kink hoses when handling
pump.
NOTE
Hydraulic pump P/N 938555
(145HS100-3) is no longer the correct
configuration after completion of ECP
D213 and turnaround program (TB
1-1520-240-20-75). The correct P/N
is 145HS100-4.
22.
Pack splines of utility hydraulic system pump
(52) and mating splines in transmission (1) with
grease (E190). Install pump, with packing (53)
and gasket (53.1), on four studs (54). Install nuts
(55). Torque nuts to 85 inch-pounds.
NOTE
Torque on nuts (51 and 55) must be
checked for 85 inch-pounds after the
first flight. Do not back off nuts before
checking torque.
6-370
