TM 55-1520-240-23-4
5-117.1
DISASSEMBLE AND INSPECT FWD AND AFT SWASHPLATE ASSEMBLY
BEARINGS (Continued)
5-117.1
ASSEMBLE SWASHPLATE
7.
For forward swashplate assembly only, assemble
as follows:
a.
Use cloths (E134.1) damp with acetone
(E20). Clean stationary ring assembly
(11) studs. Wipe area dry with clean cloth
(E134.1). Wear gloves (E184.1).
b.
Position seal (2) on stationary ring (11).
c.
Install 12 nuts (3) and washers (4). Torque
nuts 190-200 inch-pounds.
INSPECT
d.
Check that clearance between seal (2) and
seal (12) is 0.005 to 0.070 inch.
e.
Lubricate bearing (13) through fitting (14)
(Task 1-90). Use grease (E190). Turn rotating
ring (15) one full circle while greasing until a
fillet of grease appears between grease seals
(2 and 12). Use hand lubricating gun.
INSPECT
f.
Wipe off excess grease around stationary
grease seal. Use cloth (E134.1). Wear
gloves (E184.1).
g.
Use cloths (E134.1) damp with acetone
(E20). Clean stationary ring assembly (11)
hardware and studs (16). Wipe area dry with
clean cloth (E134.1). Wear gloves (E184.1).
h.
Touch up hardware using one coat of epoxy
primer (E292.1). Wear gloves (E184.1).
Change 1
5-666.3
