TM 55-1520-240-23-4
5-117.1
DISASSEMBLE AND INSPECT FWD AND AFT SWASHPLATE ASSEMBLY BEARINGS
5-117.1
INITIAL SETUP
Applicable Configurations:
All
Tools:
Powertrain Repairer’s Tool Kit, NSN
5180-00-003-5267
Hand Lubricating Gun
Torque Wrench, 100 to 750 Inch-Pounds
Materials:
Cloth (E134.1)
Brush (E86)
Alodine (E65)
Acetone (E20)
Gloves (E184.1)
Grease (E190)
Lockwire (E233)
Epoxy Primer (E292.1)
Abrasive Paper (E14)
Personnel Required:
Aircraft Powertrain Repairer
Inspector
References:
TM 55-1520-240-23P
Equipment Condition:
Install Servo Cylinder Safety Blocks (Task 11-28)
Pitch Link Lockpins Installed (Task 5-96.1)
General Safety Instructions:
Alodine (E65) is an oxidizer. Discard
cloths which contain this material in a
separate container. If discarded with
cloths contaminated with acetone,
MEK, or other organic solvents,
combustion can result. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
eyes.
A54803
Acetone (E20) is extremely
flammable. It can be toxic. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. Keep away from
heat, sparks, or open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
eyes.
Epoxy primer (E292.1) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat and open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
5-666 Change 1
