TM 55-1520-240-23-4
5-48.9
INSTALL DROOP STOP SHROUD ASSEMBLIES
(Continued)
5-48.9
INSTALL BASE
5.
Align slots (13) of droop stop shroud base (14)
with shaft (15). Slide base on shaft.
6.
Install bushings (16), flange outboard, on shaft
(15).
7.
Install washers (17) and nuts (18). Do not tighten
nuts at this time.
8.
Install four washers (19) and bolts (20) in base
(14). Torque bolts to 70 inch-pounds.
9.
Install washer (21) and bolt (22) in base (14).
Torque bolt to 70 inch-pounds.
10.
Tighten two nuts (18) until rubber of bushings
(16) is compressed 0.010 to 0.030 inch and
cotter pin holes are aligned with nut slots. Use
additional washers (17) if required. Install cotter
pins (23).
5-222