TM 55-1520-240-23-3
4-121
ASSEMBLE ENGINE DROOP ELIMINATOR VARIABLE RESISTORS
4-121
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Electrical Repairers Tool Kit, NSN 5180-00-323-4915
Multimeter
Materials:
None
Personnel Required:
Aircraft Electrician
Inspector
References:
TM 55-1520-240-23P
1.
Connect multimeter (1) to terminals 1 (2) and
2 (3) on resistor (4). Set multimeter to RX1.
Extend shaft (5) to 2.87 inches. Multimeter shall
indicate 58 to 62 ohms.
2.
Repeat step 1 on resistor (6).
3.
Position two resistors (4 and 6) on two plates
(7). Secure two resistors to two plates with four
screws (8).
4-422