TM 55-1520-240-23-3
4-74.1
REMOVE ENGINE AIR INLET FAIRING
4-74.1
INITIAL SETUP
Applicable Configurations:
With 74
Tools:
Aircraft Mechanics Tool Kit, NSN 5180-00-323-4692
Sling (T134)
Hoist
Materials:
Paper Tags (E264)
Masking Tape (E388)
Personnel Required:
Medium Helicopter Repairer (3)
References:
Task 4-50
Equipment Condition:
Engine Work Platform Open (Task 2-2)
Engine Drive Shaft Removed (Task 6-30)
Remove Engine Mount Adapter (Task 4-29.1)
Engine Access Cover Open (Task 4-49)
Engine Air Inlet Screens Removed (Task 4-65)
Engine Transmission Fairing Removed (Task 4-70)
NOTE
Procedure is same to remove No. 1
or No. 2 engine air inlet fairing. No.
2 fairing is shown here.
1.
Remove nut (1) and screw (2) from clamp (3) at
lower lifting lug (4). Release temperature and
chip detector wire (5).
2.
Disconnect cable plug (6).
3.
Tag and disconnect three hoses (7). Use paper
tags (E264).
4-316