TM 55-1520-240-23-3
4-74
REMOVE ENGINE AIR INLET FAIRING
4-74
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Aircraft Mechanics Tool Kit, NSN 5180-00-323-4692
Sling (T134)
Hoist
Materials:
Paper Tags (E264)
Masking Tape (E388)
Personnel Required:
Medium Helicopter Repairer (2)
References:
Task 4-50
Equipment Condition:
Engine Work Platform Open (Task 2-2)
Engine Mount Adapter Removed (Task 4-29)
Engine Access Cover Open (Task 4-49)
Engine Air Inlet Screens Removed (Task 4-65)
Engine Transmission Fairing Removed (Task 4-70)
Engine Drive Shaft Removed (Task 6-30)
NOTE
Procedure is same to remove No. 1
or No. 2 engine air inlet fairing. No.
2 fairing is shown here.
1.
Remove nut (1) and screw (1.1) from clamp (1.2)
at lower lifting lug (1.3). Release temperature
and chip detector wire (1.4).
1.1.
Disconnect cable plug (1.5).
2.
Tag and disconnect three hoses (2). Use paper
tags (E264).
4-312