TM 55-1520-240-23-9
11-239
INSTALL TUNNEL AFT CONNECTING LINKS
(Continued)
11-239
NOTE
Procedure is same for left and right
connecting links except as noted in
task. Right side at sta. 401 is shown
here.
4.
Position link (1) and tunnel connecting link (8)
in control arm (9).
5.
Install bolt (10), two washers (11 and 12), and
nut (13). Torque nut to 60 to 90 inch-pounds.
Install cotter pin (14).
6.
Check bolt (10). Bolt shall not rotate with torque
less than 10 inch-pounds. Bolt shall have no
axial looseness. If bolt rotates or is loose, add
washer under nut and repeat step 5.
11-931