• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPLACE FUEL QUANTITY  SYSTEM  COAXIAL CONNECTOR  CONTACTS (Continued) - TM-55-1520-240-23-7_285
TEST HYDRAULIC  PRESSURE  INDICATOR

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  255    256    257    258    259  260  261    262    263    264    265  
TM  55-1520-240-23-7 8-82.1 REPLACE FUEL QUANTITY  SYSTEM  COAXIAL CONNECTOR  CONTACTS (Continued) 8-82.1 ASSEMBLY  PROCEDURE  FOR  CRIMP  TYPE SOCKET Prepare cable as shown in steps  21 thru 25. Do  not  exert  more  than  1  pound pressure  to  seat  inner  contact. Damage  to  contact  could  occur  if more  than  1 pound  pressure  is used. NOTE After  seating  inner  contact,  support contact  cable  assembly  until  crimp sleeve  is  installed  to  prevent  strain  on inner  contact crimp  joint. 32. Push  inner  contact  (30)  onto  contact  outer  body (34)  until  inner  contact  seats. 33. Fold  cable  outer  braid  (26)  over  back  of  contact (34). NOTE After  crimping,  trim  any  braid protruding  from  between  crimp  sleeve and  contact  shoulder  as  close  as possible. 34. Slide  crimp  sleeve  (33)  forward  over  the  exposed braid  (26).  Crimp  sleeve.  Use  crimper  MH800. INSPECT FOLLOW-ON  MAINTENANCE: None END  OF  TASK 8-270







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.