• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL CENTRIFUGAL DROOP STOP  BALANCING ARM (Continued)
REMOVE CENTRIFUGAL DROOP STOP  SUPPORT AND BLOCKS (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  251    252    253    254    255  256  257    258    259    260    261  
TM  55-1520-240-23-4 5-60 REMOVE  CENTRIFUGAL DROOP  STOP SUPPORT AND BLOCKS 5-60 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Drift,  Aluminum  or  Phenolic Materials: None Personnel  Required: Medium  Helicopter Repairer (5) Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Hydraulic  Power Off Aft  Pylon  Work  Platforms Open  (Task 2-2) Tiedown  Line  Installed  On  One  Forward  and  One  Aft Blade  (Task  1-26) Droop  Stop  Shrouds  Removed  (Task  5-48.3) General Safety Instructions: Do  not  lower  blade  suddenly. Personnel  can  be  injured  if  blade  is lowered  suddenly  while  droop  stop work is  in  progress. NOTE There  are  three  centrifugal  droop  stop supports  and  blocks. Procedure  is  same  to  remove  any centrifugal  droop  stop  support  and blocks. One  rotor  blade  is  connected  to support  and  blocks of each  centrifugal droop  stop. Blade  for  support  and  blocks  to  be removed  must  be  positioned  over fuselage. 1. Position  blade  (1) over fuselage  (2).  Use  tiedown line  (3).  Tie  down  one  forward  and  one  aft blade. 5-257







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.