• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL CENTRIFUGAL DROOP STOP  SPRINGS  AND WEIGHTS (Continued) - TM-55-1520-240-23-4_271
REMOVE  CENTRIFUGAL DROOP  STOP  BALANCING ARM

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  246    247    248    249    250  251  252    253    254    255    256  
TM  55-1520-240-23-4 5-57 INSTALL CENTRIFUGAL DROOP  STOP  SPRINGS  AND WEIGHTS (Continued) 5-57 6. Install  extension  spring  (8)  and  inboard  limiter spring  (9)  on  hub  oil  tank  lugs  (18)  as  follows: a. Position  bearing  (19)  in  grommet  (7)  and ends  of  limiter  spring  (9). b. Position  two  washers  (20)  over  ends  of bearing  (19). c. Have  helpers  lift  and  support  blade (21)  at  tip. d. Lift  balancing  arm  (22). e. Extend  spring  (8)  to  position  bearing  (19) between  lugs  (18). f. Install  bolt  (23),  head  toward  pitch-varying housing  (14),  through  lugs  (18)  and  bearing (19). g. Install  nut  (24).   Torque  nut  to  12 to  15 inch-pounds.   Install  cotter  pin  (25).   Use washers  (26)  if  needed  to  align  cotter  pin. h. Have  helpers  lower  blade  (21). INSPECT FOLLOW-ON  MAINTENANCE: Install  droop  stop  shrouds  (Task  5-48.5). Close  work  platform  (Task  2-2). END  OF  TASK 5-252







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.