• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  CENTRIFUGAL DROOP STOP  SUPPORT AND  BLOCKS (Continued) - TM-55-1520-240-23-4_279
INSTALL CENTRIFUGAL DROOP STOP  SUPPORT AND  BLOCKS (Continued) - TM-55-1520-240-23-4_281

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  254    255    256    257    258  259  260    261    262    263    264  
TM  55-1520-240-23-4 5-61 INSTALL  CENTRIFUGAL DROOP  STOP  SUPPORT AND BLOCKS 5-61 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft  Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Torque  Wrench,  30  to  150  Inch-Pounds Materials: Cloth  (E120) Lockwire  (E229) Epoxy  Primer  (E292  and  E292.1) Gloves  (E184.1) Personnel  Required: Medium  Helicopter  Repairer  (5) Inspector References: TM  55-1520-240-23P Task  5-49 General  Safety Instructions: Do   not  lower  blade   suddenly. Personnel  can  be  injured  if  blade  is lowered  suddenly  while  droop  stop work  is  in  progress. Epoxy  primers  (E292  and  E292.1)  are flammable  and  toxic.  They  can  irritate skin  and  cause  burns.   Use  only  with adequate  ventilation,  away  from  heat and  open  flame.   In  case  of  contact, immediately  flush  skin  or  eyes  with water  for  at  least  15 minutes.   Get medical  attention  for  eyes. 5-260







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.