• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL CENTRIFUGAL DROOP STOP  SPRINGS  AND WEIGHTS (Continued) - TM-55-1520-240-23-4_272
REMOVE  CENTRIFUGAL DROOP STOP  BALANCING ARM (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  247    248    249    250    251  252  253    254    255    256    257  
TM  55-1520-240-23-4 5-58 REMOVE  CENTRIFUGAL DROOP  STOP  BALANCING ARM 5-58 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Drift,  Soft  Aluminum,  3/4  Inch  Diameter Materials: None Personnel  Required: Medium  Helicopter Repairer (2) Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Hydraulic  Power Off Pylon  Work  Platform  Open  (Task  2-2) Springs  and  Weights  Removed  (Task  5-56) Tiedown  Line  Installed  On  One  Forward  and  Two  Aft Blades  (Task  1-26) NOTE There  are  three  balancing  arms. Procedure  is  same  to  remove  any balancing  arm. 1. Position balancing  arm (1) over work platform  (2). Tie  down  two  blades (3).  Tie  blade  (4)  to  forward towing  shackle  (5).  Use  tiedown  lines  (6). 5-253







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.